Problem
Possible cause
Solution
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set.
The "COOLMATIC function"
is switched on.
Switch off "COOLMATIC
function" manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "COOL-
MATIC function".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if neces-
sary.
The COOLMATIC function is
switched on.
Refer to "COOLMATIC func-
tion".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was opened too fre-
quently.
Open the door only when
necessary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrap-
ped.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of
the door.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
8.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
ENGLISH
55
Summary of Contents for AIK2223R
Page 58: ...www aeg com 58 ...
Page 59: ...ENGLISH 59 ...
