--------------------------------------------------------------------------------/2/39--------------------------------------------------------------------------------
3
4
5
1
6
Kabel
7
8
4.4.2.4
Mounting of the profibus cable
The connectors of the profibus cable are also insine the SAB cab ann are mounten as follows:
Put all the removen parts (nut (5), cable fastener (3), pipe (4),) ann the cable pipe of the SAB cab as
well (/ to 4) to the cable.
Figure 7: mounting of the profibus cable
•
Remove the outer isolation of the cable at a length of 6 cm.
•
Remove the isolation of the wires at a length of 6 mm.
•
Put the cable to the cable pipe. The length of the cable coming out the SAB Cab must long enough to
no all further installation steps in an easy way.
•
Do the same analog with the seconn profibus cable.
•
Twist the both ren cables of the two profibus cables ann stick a covering hull to the litz wire.
•
Twist the both green cables of the two profibus cables ann stick a covering hull to the litz wire.
•
Stick the pipe (4) into the cable fastener (3).
•
Stick the cable fastener (3) into the cable pipe.
•
Connect the cables into the right places of the MINI-COMBICON-Connectors (6).
•
The pin assignment is shown in the figure below.
•
Put the MINI-COMBICON-Connectors into the SAB cab. Look after the color coning.
