41
PD201806 AEG GRID-TIED SINGLE-PHASE SOLAR INVERTER V.1-18 EN
41
Pin on inverter
Definition
1 +5VDC
2 A
(RS485+)
3 B
(RS485-)
4 GND
Table 22: Pins on inverter detail
6.2 Optional communication
WiFi is the standard communication mode for the AEG AS-IR01 and AS-IR01-2. Optional communication modes include
Ethernet, which also needs corresponding communication parts and components. All operation parameters of the
inverter will be transferred through RS485 port, and then to the communication devices. These allow the transfer of the
monitoring data to the monitoring system (Web Portal / App).
If you need further information on optional communication possibilities, please contact the AEG technical service.
6.3 AEG WiFi200 (AEG WiFi Stick) communication module
6.3.1 AEG WiFi Stick product overview
The AEG WiFi200 communication module (hereinafter referred to as “AEG WiFi Stick”) is a device enabling the
transmission of relevant performance data from your AEG inverter to the monitoring software (AEG InverterControl App
and AEG InverterControl Monitoring Webportal).
It allows users to configure inverter parameters, and control and
monitor the inverter locally and remotely. The WiFi Stick fits the RS485 port of the AEG inverters.
WiFi is the standard communication mode for the AEG AS-IC01 and AS-IC01-2. The AEG WiFi Stick features one RS485
and one WiFi communication port for the data transmission. The AEG WiFi Stick features a general serial port which
meets the network standards and has built-in TCP/IP protocol stack for the transformation between the user serial port
and WiFi port.
Below is an overview of the AEG WiFi Stick features:
Interface
Parameters function
RS485
interface
1.
Automatic control of data flow, automatic identification and transmission
direction of control data and no handshake signal is needed
2.
Transmission speed 300~115200 Baud
3.
Up to 32 devices of RS485
4.
the maximum transmission distance 1200m
