2.
Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3.
Pull the door trim to the front to re-
move it.
4.
Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5.
Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem
Possible cause
Solution
The oven does not heat up
The appliance is switched off
Switch on the appliance
The oven does not heat up
The clock is not set
Set the clock. Refer to "Setting
the clock"
The oven does not heat up
The necessary settings are not
set
Make sure, the settings are cor-
rect
The oven does not heat up
The automatic cut
-
out is
switched on
Refer to „Automatic cut
-
out“
The oven does not heat up
The fuse is released
Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
The oven lamp does not oper-
ate
The oven lamp is defective
Replace the oven lamp.
The pyrolytic cleaning does not
operate (the clock display
shows „C1“)
The shelf support/telescopic
runners are not removed
Remove support/telescopic
runners
B
What to do if…
29