A
A
3.
Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is
free to move. Make sure,
that both hinge-arms are in
the same position
(approximately 70° angle).
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
11.9
Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1.
Turn off the oven.
Wait until the oven is cooled down.
2.
Disconnect the oven from the mains.
3.
Put a cloth on the bottom of the
cavity.
The top lamp
1.
Turn the lamp glass cover to remove
it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
12.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
ENGLISH
33
Summary of Contents for BCS551020M
Page 1: ...USER MANUAL EN User Manual Oven BCS551020M ...
Page 38: ...www aeg com 38 ...
Page 39: ...ENGLISH 39 ...