Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the complete procedure
is about 2 hours.
The light in this function is off.
1.
Make sure that the water drawer is
empty.
2.
Press
.
3.
Put the grill- / roasting pan on the
first shelf position.
4.
Press
.
5.
Put 250 ml of the descaling agent in
the water drawer.
6.
Fill the remaining part of the water
drawer with water to the maximum
level until the signal sounds or the
display shows the message.
7.
Press
.
This activates the first part of the
procedure: Descaling.
The duration of this part is
around 1 hour 40 minutes.
8.
After the end of the first part, empty
the grill- / roasting pan and put it on
the first shelf position again.
9.
Press
.
10.
Fill the water drawer with fresh water
to the maximum level until the signal
sounds or the display shows the
message.
11.
Press
.
This activates the second part of the
procedure: Descaling. It will rinse the
steam generation circuit.
The duration of this part is
around 35 minutes.
Remove the grill- / roasting pan after the
end of the procedure.
If the function: Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the oven is humid or wet, wipe it out
with a dry cloth. Let the oven dry fully
with the door open.
12.7
Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate
each time you switch off the appliance.
The soft reminder reminds and
recommends you to perform the
descaling cycle.
The hard reminder obligates you to
perform the descaling.
If you do not descale the
appliance when the hard
reminder is on, you cannot
use the steam functions.
You cannot disable the
descaling reminder.
12.8
Steam generation system
- Rinsing
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the function is around 30
minutes.
The light in this function is off.
1.
Put the baking tray on the first shelf
position.
2.
Press
.
3.
Fill the water drawer with fresh water
to the maximum level until the
acoustic signal sounds or the display
shows the message.
4.
Press
.
Remove the baking tray after the end of
the procedure.
12.9
Tank Emptying
Remove all accessories.
The cleaning function removes the
residual water from the water drawer.
Use the function after the steam cooking
function.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
www.aeg.com
48