Problem
Possible cause
Remedy
The lamp does not operate.
The lamp is defective.
Replace the lamp.
The display shows F111.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
The display shows an error
code that is not in this table.
There is an electrical fault.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The descaling procedure is
interrupted before it finishes.
There was a power cut.
Repeat the procedure.
The descaling procedure is
interrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
You did not fill the water
drawer to the maximum lev-
el.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is on
a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
The cleaning function is in-
terrupted before it finishes.
There was a power cut.
Repeat the procedure.
The cleaning function is in-
terrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.
There is no good perform-
ance of the cleaning proce-
dure.
The initial oven cavity tem-
perature of the steam clean-
ing function was too high.
Repeat the cycle. Run the cy-
cle when the appliance is
cold.
ENGLISH
51