heat settings of the cooking zones
manually, if necessary.
• The hood extractor is always available
as an electrical load.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
5.8 Hood functions
WARNING!
Refer to Safety chapters.
Activating and deactivating
the hood
The hood can operate alongside the hob
during the cooking session, as well as
while the hob is switched off.
1. Press one of the fan speed levels
(1-3) on the hood control bar to
activate the hood.
A signal sounds and indicators above the
hood control bar appear.
2. Adjust the fan speed setting as
needed by pressing either of the
available levels on the hood control
bar.
3. To deactivate the hood, press 0 on
the hood control bar.
The indicators above the hood control
bar disappear.
AUTO
The function automatically adjusts the
fan speed level based on the selected
heat setting level of the hob.
When you use the hob for the first time,
the function is usually activated by
default.
You can activate the function while the
hob is on but none of the cooking zones
are active, or at any point during the
cooking session.
If you activate the function
while the hob is off, none of
the cooking zones operate
and there is no residual heat
visible on the control panel,
the function will switch off by
itself after a few seconds.
1. Press and hold to activate the
hob.
2. Press AUTO to activate the function.
A signal sounds and an indicator above
the symbol appears.
3. Place cookware on the hob and
select a heat setting level. Increase
or decrease the heat setting level as
needed.
The hood will react to the heat setting
level, increasing or decreasing the fan
speed level accordingly. The indicators
above the hood control bar appear.
4. Press 0 on the hob control bar to
deactivate a cooking zone or to
deactivate the hob.
If the residual heat indicator appears,
AUTO will continue to adjust the fan
speed. If the remaining heat is low,
Breeze might start operating as well.
5. To deactivate the function during
cooking and switch to the manual
mode of the hood, press AUTO or
any other setting on the hood control
bar.
A signal sounds and the indicator above
the symbol disappears.
www.aeg.com
14
