2. Clean the hood cavity with a cleaning
foam.
3. Wash the filter and filter housing
manually in warm water without using
detergents or abrasive sponges. You
can also wash them in a dishwasher
with the maximum temperature of
65-70 °C, without detergents and
without dishes in the same load. Only
the plastic parts can be cleaned
using detergents.
4. Fix the filter and filter housing back in
place when they are fully dried.
5. Reset the counter.
Resetting the counter when the filter
indicator is on:
1. Clean the filter first and place it back
inside the hood.
2. Press briefly, while the indicator is
blinking. The counter restarts.
Resetting the counter before the filter
indicator appears:
1. Make sure the hob is switched off
and Child Safety Device does not
operate.
2. Clean the filter and place it back
inside the hood.
3. Press twice. The indicator
appears and the signal sounds. The
counter restarts.
The counter starts automatically when
you turn on the hood for the first time.
The maximum number of cleaning cycles
is 8. After that time, the filter needs to be
replaced with a new one.
WARNING!
An oversaturated filter can
pose a risk of fire.
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
Possible cause
Remedy
You cannot activate or op‐
erate the hob.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply.
The fuse is blown.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
ENGLISH
21
