Supply piping should not be
less than R3/8. Connection is
made to the Rc 1/2 (1/2
“ B.S.P.) female threaded.
The entry pipe is located just
below the hob level on the
rear left hand side of the
appliance.
The gas supply ramp is on
the rear side of the
appliance.
WARNING!
Only liquid sealants can be
used when the inlet gas pipe
is fitted i.e.: do not use the
P.T.F.E. sealant tape.
When the installation is
complete, carry out a gas
tightness test and make sure
that the seal of each pipe
fitting does not leak.
Use flexible tubing, which
comply with the BS.669
current edition.
A
B
C
C
D
E
WARNING!
The gas bayonet connector
must be in the marked area.
Dimension
mm
A
250
B
680
C
50
Dimension
mm
D
250
E
580
3.8
Pressure test
The Rapid injector is used as a pressure
test point.
1.
Connect the pressure gauge to the
Rapid injector.
2.
Examine the supply pressure by
turning the Rapid burner and one
other burner fully on, and lighting
them. The pressure must be 20 mbar
for Natural Gas.
3.
Turn the taps off and disconnect the
pressure gauge.
4.
Make sure that all burners work
correctly.
3.9
Checking the hob burners
1.
Lift the lid.
2.
Put on the burner crowns and caps.
Make sure that they are correctly
seated.
3.
Put on the pan supports.
4.
Light one of the hob burners.
To light the hob burner refer to the
"Ignition of the hob burners".
Check if the flame is regular.
Check each of the burners.
5.
Turn the knob for the hob to the off
position.
3.10
Checking the oven
burners
1.
Put in the deep pan and the trivet.
2.
Light the oven burner.
To light the oven burner refer to the
"Ignition of the oven burners".
Check if the flame is regular.
3.
Turn the knob to the off position.
3.11
Checking the Lid Safety
Device
1.
Lift the lid.
2.
Light one of the hob burners.
To light the hob burner refer to the
"Ignition of the hob burners".
www.aeg.com
10
Summary of Contents for CGB6130ACM
Page 1: ...USER MANUAL EN User Manual Cooker CGB6130ACM ...
Page 31: ...ENGLISH 31 ...