CAUTION!
Make sure that the longer
fixing wire is in the front. The
ends of the two wires must
point to the rear. Incorrect
installation can cause
damage to the enamel.
12.5 Removing and cleaning
the door glasses - top oven
The door glass in your
product can be different in
type and shape from the
examples you see in the
image. The number of
glasses can also be
different.
1. Open the door.
2. Hold the door trim on the top edge of
the door at the two sides and push
inwards to release the clip seal.
1
2
1
3. Pull the door trim to the front to
remove it.
4. Remove the glass panels.
To install the panels, do the same steps
in reverse.
12.6 Removing and cleaning
the door glasses - main oven
The door glass in your
product can be different in
type and shape from the
example you see in the
image. The number of
glasses can also be
different.
1. Push the door trim at one side to
remove it.
1
2
A
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
12.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
www.aeg.com
34