General Information
Carefully read the following important information regarding installation, safety
and maintenance of your appliance. This appliance has been designed for use in
the venting mode (air exhaust to the outside – Fig.1B), recirculation mode (air
circulation on the inside – Fig.1A) or with venting mode with external motor
(Fig.1C). The cooker hood is designed to extract unpleasant odours from the
kitchen, it will not extract steam
Safety Warnings
Always cover lighted elements, to prevent excess heat from damaging the
appliance. In the case of oil, gas and coal fired cookers it is essential to
avoid open flames
Also, when frying, keep the deep frying pan on the cooker top under careful
control
It is extremely important to note that overheating can cause a fire
Never carry out flambé cooking under the hood
There must be adequate ventilation in the room when the range hood is
used at the same time as appliances burning gas or other fuels
It is very important to clean the hood and replace the filter at the
recommended intervals. Failure to do so could cause grease deposits to
build up, resulting in a fire hazard
Always disconnect the unit from the power supply before carrying out any
work on the hood, including replacing the light bulbs
The appliance is not intended for use by young children
Ensure that the appliance is switched off before replacing the lamp to avoid
possibility of electric shock
Do not check the status of the filters while the cooker hood is operating
Do not touch bulbs or adjacent areas, during or straight after prolonged use
of the lighting installation
3
Summary of Contents for Competence 6292D-M
