AEG CS 5 SERIES, Operating Instructions Manual

g

30

• Only clean the 

milk frother

 when the 

machine is switched off, cold and not 
under pressure!

• Do not clean coffee machine parts in 

the dishwasher.

•

Never put water in the grinder.

 This 

would damage the grinder.

Never open or repair the coffee 
machine. Faulty repairs can result in 
considerable hazard to the user.
Repairs to electrical appliances must be 
carried out only by qualified service 
engineers.
If a repair becomes necessary, includ-
ing replacement of the mains lead, 
please contact

• the dealer where you bought the cof-

fee machine, or

• the AEG/Electrolux Service Line.

If the machine is misused or incor-
rectly operated the manufacturer 
accepts no liability for damage and 
the guarantee is invalidated - like-
wise if the descaling program is not 
carried out in accordance with these 
operating instructions immediately 
after the  

 light flashes. Block-

ing or damage caused by foreign 
objects in the grinder might be 
excluded from the guarantee.

3

Before using for the first 
time

3.1

Setting up and connecting the 
coffee machine

0

After unpacking, make sure the appli-
ance is complete and undamaged. If in 
doubt, do not use it. Contact profes-
sionally qualified personnel. 

0

Place the appliance on a work surface 
far away from water taps, basins and 
sources of heat. 

1

After having positioned the appliance 
on the work bench, make sure that 
there is a free space of around 5 cm 
between the surfaces of the appliance 
and the side and rear walls and a free 
space of at least 20 cm above the cof-
fee maker. 
Never install the machine in environ-
ments where the temperature may 
reach 0 °C or lower (the appliance may 
be damaged if the water freezes). 

1

Check that the voltage of the mains 
power supply corresponds to the value 
indicated on the appliance's type plate. 
Only connect the appliance to a power 
outlet with a minimum rating of 10 A 
that is properly earthed. The manufac-
turer declines all liability for any acci-
dents caused if the system is not 
correctly earthed. 

1

If the power outlet does not match the 
plug on the appliance, have the outlet 
replaced with a suitable type by quali-
fied personnel. 

0

Plug the coffee machine into the 
power outlet.
If the coffee machine is plugged in for 
the very first time, all lights come on 
for a few seconds for a check, then all 
lights go off.

3

The water hardness should be set as 
soon as possible, following the proce-
dure described in the section 9.5 „Set-
ting the water hardness“, page 38. 

822_949_352 CS5200.book  Seite 30  Mittwoch, 9. Mai 2007  7:26 19