AEG CS 5 Operating Instructions Manual Download

Page: 34 / 268

Adjusting the coffee
grinder

The coffee grinder must not be
adjusted, at least initially, as it has
already been pre-set in the factory for
the correct delivery of the coffee.
Nonetheless, after having made the
first coffees, if delivery is too fast or
too slow (in drops), the grinding
coarseness must be adjusted using the
knob (Fig.17) located inside the bean
container.
These adjustments will only be evident
after the delivery of at least 2 cups of
coffee.

The grinder setting may be changed
only while coffee is being ground.
Making adjustments to the stationary
grinder can damage the coffee
machine.

Turn one click (one number) anticlock-
wise for finer ground coffee and con-
sequently slower delivery and a
creamier appearance (Fig. 18).

Turn one click (one number) clockwise
for coarser ground coffee and conse-
quently faster delivery (not a drop at a
time) (Fig. 18).

The machine has been tested in the
factory using coffee and therefore it is
completely normal to find some traces
of coffee in the grinder. The machine is
in any case guaranteed to be new.

Using pre-ground coffee

Press the

button to select the

ground coffee function (Fig. 19).
The

light switches on to indicate

that the function has been selected
and the coffee grinder has been disa-
bled.

Lift the lid in the centre, insert one (for
1 cup) or two (for 2 cups) pre-ground
coffee measures in the funnel (Fig. 20).

Adjust the coffee quantity selector
knob (Fig. 10) to set the quantity of
coffee required.
Turning the knob clockwise makes a
longer coffee.

Place one cup under the spouts to
make 1 coffee or 2 cups for 2 coffees
(Fig. 11). For a creamy coffee, lower the
spouts to bring them as close to the
cups as possible (Fig. 12).

Press the button

(Fig. 13) to make

one cup of coffee or the button

(Fig. 14) to make 2 coffees.

Note 1:

Never add the ground coffee

when the machine is off, to prevent it
from spilling inside the machine.

Note 2

: Never add more than 2 meas-

ures, otherwise either the machine will
not make the coffee and the pre-
ground coffee will be lost inside the
machine, dirtying it, or the coffee will
be run off in drips.

Note 3:

When dosing the quantity of

coffee to be added, only use the meas-
ure supplied.

Note 4:

Only use ground coffee for

espresso coffee makers: do not use cof-
fee beans, freeze-dried coffee or other
materials that may damage the
machine.

Note 5:

If you add more than two

measures of pre-ground coffee and the
funnel blocks, use a knife to push the
coffee down (Fig. 21) and then remove
and clean the infuser and the machine,
as described in section 9.3 „Cleaning
the infuser“, page 37.

Once the coffee has been delivered, to
make coffee using the beans again,
deactivate the ground coffee function
by pressing the

button again (the

light goes off and the coffee grinder is
enabled for operation again).

Please observe also section 4 „Making
coffee with beans“, page 32, notes no.
3 - 7, 9 and 10.

822_949_352 CS5200.book Seite 34 Mittwoch, 9. Mai 2007 7:26 19