RESET FUNCTION
RESET
button (24) must be activated
with either a ballpoint pen or thin metal
object.
The
RESET
button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press
RESET
button (24), the unit
can't work yet, please use a cotton swab
socked in isopropyl alcohol to clean the
socket on the front panel.
OPERATION
FM1 FM2 FM3
RADIO OPERATION
SWITCHING TO RADIO MODE
Press
MOD
button (6) shortly to select
radio mode, the radio mode appears
in the display together with the
memory band an frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press
BND/LOU
button
(13) shortly to select the desired band.
The reception band will change in the
following order:
SELECTING STATION
Press button(17) or button
(16) shortly to activate automatic
seek function. Press for several
seconds until "
MANUAL
" appears on
the display, the manual tuning mode
is selected. If both buttons have not
been pressed for several seconds,
they will return to seek turning mode
and "
AUTO
" appears on the display.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press
AMS
button (18) for several
seconds, the radio searches from
the current frequency and checks
the signal strength until one cycle
search is finished, And then 6
strongest stations are stored into
the corresponding preset number
button.
- Program scanning
Press
AMS
button (18) shortly to
scan preset station, When the
field strength level is more than
the threshold level of stop level,
the radio is holding at that preset
number for several seconds with
release mute, then searches
again.
STATION STORING
Press any one of the preset buttons
(14) (1 to 6) to select a station,
which had been stored in the
memory. Press this button for
several seconds (until 2ND beeps
come out), current station is stored
into the number button.
RDS (RADIO DATA SYSTEM)
OPERATION
- Setting RDS mode
Press
AF
button (3) and release
immediately to switch on or off
RDS mode.
Whenever RDS is switch on,
symbol “
AF
” appears on the
display.
Program name is displayed on
receiving a RDS station.
“
AF
” starts blinking if the
broadcasting signal getting worse.
“
ALARM
” will be displayed when
an emergency broadcasting is
received, meanwhile sound output
level will be adjusted to the preset
output level automatically when
the volume control is set at
minimum.
- Regional Program Operation
Press
AF
button (3) for several
seconds to switch on or off region
mode.
Some broadcasting stations
change their program from normal
broadcasting to regional
11
