English
37
12. Connect the cable harness from the motor housing to
the mounting bar. Also connect the ground wire from the
spacer tube to the cable eye on the mounting bar.
NOTE:
In order to facilitate installation:
You may attach one screw hole of the baldachin to the
hook on the mounting bar.
13. Attach the fan by remounting the baldachin to the
mounting bar (see page 4 / 8). Make sure the pin of the
baldachin is aligned with the notch on the black cap of
the spacer tube. Tighten the four screws on the mounting
bar.
14. Attach the fan blades (6) to the mounting brackets (10).
Use the 15 screws (M5*15) and 15 washers. Tighten the
screws until hand-tight. (See page 4 / 9).
15. Remove the three transportation locks (see page 4 /
10) and the other 7 preinstalled screws from the motor
housing.
Important!
Do
not
remove the padding located
underneath (see page 4 / 11).
16. Attach the assembled fan blades using the 10 screws and
10 spring washers removed earlier. (See page 4 / 12)
17. Remove the 3 preinstalled screws from the 3-part lamp
attachment.
18. Connect the power supply from the motor housing to the
cable eye (LIGHT) on the lamp attachment.
19. Insert the lamp attachment. Make sure the notch on the
lamp attachment is located above the switch for setting
the rotation direction. (See page 4 / 13). Attach the lamp
attachment using the 3 screws, washers and spring wash-
ers removed earlier.
20. Install the two pull chains (5/8).
21. Install the luminous elements in the sockets. In order to
do so, use the provided suction cup to tighten the illumi-
nant. (See page 4 / 14)
Operation
Fan
Use the switch (11) on the motor housing to set the rotation
direction of the fan blades. (Summer/winter operation)
CAUTION:
Only adjust the direction when the fan blades stand still.
Otherwise the motor could be damaged.
• Summer operation: Set the switch to “
“ position.
• Winter operation: Set the switch to “
“ position.
NOTE:
Winter operation might be without any result depending
on the size of the room.
Repeatedly pull the pull chain (5) on the motor housing to set
the speed of the fan blades.
1x = high speed
2x = medium speed
3x = low speed
4x = Fan is turned off.
Lighting
Repeatedly pull the pull chain (8) on the lamp attachment to
switch the light on or off.
Cleaning and Maintenance
WARNING:
• Always switch off the respective home circuit breaker before
carrying out any cleaning or maintenance work.
• Always wait until the fan blades have come to a complete stop.
• Wait until the luminous elements have cooled down before you
clean or maintain the fan.
• Make sure no liquid enters the electrical connections, as this
could otherwise cause electrical shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the external surface of the fan with a slightly damp
cloth.
• Dry the fan with a dry, soft cloth.
