English
40
Intended Use
This appliance is intended for ironing of clothing and textiles.
It is intended for use in households.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
Overview of the Components
1 Steam jet button
2 Connecting tube
3 Mains lead
4 Base
5 Iron rest
6 Releasing device for handle “UNLOCK“
7 Water tank with lime filter
8 Handle
9 Lock for continuous steam
10 Steam jet button
11 Selector button SET
12 Control lamp
13 Temperature selection display
14 Lime filter cartridge
not shown
RELEASE button below the water tank. Releasing device of
the water tank
Instructions
Unpacking
• Remove any protective foils and stickers from the sole
-
plate.
• Please unwind the lead completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and the
line voltage match.
• The mains plug should only be inserted into a correctly
installed 230 V ~ 50 Hz socket with earthing contact.
Power Requirements
The station has a total maximum wattage of 2400 W. With
this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm²
• Do not use any multiple sockets, as this device is too
powerful.
Turn on and off
Turn on:
Connect the mains plug to a properly
installed 230 V~ 50 Hz safety socket. The
appliance is immediately switched to
operating mode. This is indicated by the red
control lamp in the display.
Turn off:
Press the selector button SET (11) repeat-
edly until the red control lamp appears in
the display. Disconnect the mains plug from
the socket. The light in the display goes out.
Automatic shut-off function
The appliance has an automatic shut-off function.
• If the iron station is not in use it will shut off after
20 minutes. The red control lamp in the display flashes.
• Use the selector button SET (11) to reset the desired
temperature, if you want to continue ironing.
Function of the Handle (8)
The handle attached to the base
serves for carrying the appliance
when the mains plug has been
pulled from the outlet.
• To carry the appliance, raise the
handle until it engages (Fig. A). A
"click" confirms that the handle
has been locked. You can use
the handle for transport of the
appliance.
• To unlock the handle lock, press
both buttons "UNLOCK" (6) at
the same time and lower the
handle (Fig. B).
Electronic temperature adjustment using the selector
button SET (11)
• Observe the ironing instructions on the clothes label.
• Select the temperature setting according to the following
table.
• Turn woolen clothes inside out to avoid shiny spots on
the fabric due to steam ironing. In addition, lay a thin
cotton cloth onto the fabric.
• The instructions in the table only refer to fabrics with
no additional surface treatment (gloss, impregnation,
wrinkles, etc.). Select a low temperature setting for fabrics
with additional surface treatment and iron them inside
out.
• Press the selector button SET (11) to set the desired
temperature.
Summary of Contents for DBS 5591
Page 69: ......
