56
Wall unit mounting - Fig. 6
Mark the wall with a centre line, this will aid mounting procedure
(1)
,
position the template so that the mid line printed on the template
matches with the centre line previously drawn, the lower side of the
template corresponds to the lower side of the hood once mounted
(2)
.
Drill two holes Ø 8mm and fix the support bracket with two wall plugs
and screws
(3)
. Hang the hood
(4)
and adjust its position
(5-6)
.
From the inside of the hood mark two points for fixing
(7)
.
Remove the hood
(8)
and drill two holes Ø 8mm
(9)
, fit two wall plugs
(10)
.
Drill two holes Ø 8mm on the upper side close to the ceilling, fit two
wall plugs
(11)
(In case the hood is to be used in
filter version
,
mount the deflector
F
on the chimney support with four screws and
fix the chimney support
G
with two screws
(12)
.
Hang the hood again
(13)
and secure it with two screws
(14)
.
Fit an exhaust pipe
(15)
to connect the outlet hole
A
of the hood to
the outside (Extractor hood) or to the deflector
F
(Filter version).
Make electrical connection
(16)
.
Fix the chimney first up
(17a)
to the chimney support
(17b)
, then
slide the lower section of the chimney down into the housing on top
of the hood
(18)
.
