2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
10.4
Catalytic cleaning
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of
the catalytic surface have no
effect on catalytic
properties.
WARNING!
Keep children away when
you clean the oven at a high
temperature. The oven
surface becomes very hot
and there is a risk of burns.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
Before activating the
catalytic cleaning remove all
the accessories from the
oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance
operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1.
Clean the oven floor with warm water
and washing up liquid, then dry it.
2.
Set the function if applicable. If
not, set .
3.
Set the temperature to 250ºC and let
oven operate for 1 hour.
4.
When the appliance is cool, clean it
with a soft and moist sponge.
10.5
Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1.
Open the door fully.
2.
Fully lift up the clamping levers (A) on
the two door hinges.
A
A
3.
Close the door until it is at an angle
of approximately 45°.
www.aeg.com
18
Summary of Contents for DE4013001
Page 1: ...NC4013001 NC4013021 EN User Manual ...
Page 22: ...www aeg com 22 ...
Page 23: ...ENGLISH 23 ...
