4.
BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
4.1
Initial Cleaning
Remove all accessories and removable
shelf supports from the appliance.
Refer to "Care and
cleaning" chapter.
Clean the appliance before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
4.2
Setting the time
You must set the time before you
operate the oven.
Only the top oven works
without the set time.
The indicator for the Time of day
function flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the or button to set the
correct time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
4.3
Changing the time
You cannot change the time
of day if the Duration
or
End
function operates.
Press again and again until the
indicator for the Time of Day function
flashes.
To set a new time, refer to "Setting the
time".
4.4
Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat
up one oven at a time. Set
the functions listed below, if
applicable.
1.
Set the function and the
temperature to 250ºC.
Let the appliance operate for 1 hour.
2.
Set the function and the
temperature to 250ºC.
Let the appliance operate for 15
minutes.
3.
Set the function and the
temperature to 250ºC.
Let the appliance operate for 15
minutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
5.
DAILY USE
WARNING!
Refer to Safety chapters.
5.1
Retractable knobs
To use the appliance, press the control
knob. The control knob comes out.
ENGLISH
7
Summary of Contents for DE4013001
Page 1: ...NC4013001 NC4013021 EN User Manual ...
Page 22: ...www aeg com 22 ...
Page 23: ...ENGLISH 23 ...