AEG DGE7670HB, User Manual

8

www.aeg.com

4. CONTROLS

Button Function

Led

L

Turns  the  lights  on/off  at  maximum  strength.

-

T1

Turns  the  motor  on/off  at  speed  one.

-

T2

Turns the Motor on at speed two.

Fixed

Press and hold the button for approximately 3 seconds, with all the loads 

turned  off  (Motor  and  Lights),  to  turn  the Activated  Charcoal  Filter  alarm 

on. The  relevant  LED  flashes  twice  to  confirm.

To turn the alarm off, press the button again and hold for at least 3 seconds. 

The  relevant  LED  flashes  once.

Flashing

T3

Turns the Motor on at speed three.

Fixed

Press and hold the button for approximately 3 seconds, with all the loads 

turned  off  (Motor  and  Lights),  to  perform  a  reset.  The  LED 

S1

  flashes 

three times.

Flashing

T4

Turns the Motor on at 

INTENSIVE

 Speed.

This speed is timed to run for 6 minutes. At the end of this time, the system 

returns automatically to the speed that was set before. If it is activated with 

the  motor  turned  off,  the  hood  will  switch  to  OFF  at  the  end  of  the  time.

It is disabled by pressing 

T4

 or 

T1

  to  turn  off  the  motor.

Flashing

Press and hold for 3 seconds to enable the remote control, indicated by 

the  LED  flashing  twice.

Press and hold for 3 seconds to disable the remote control, indicated by 

the  LED  flashing  just  once.

Flashing

S1

Signals the Metal Grease Filter saturation alarm, indicating that it is 

necessary  to  wash  the  filters.  The  alarm  is  triggered  after  the  Hood  has 

been in operation for 100 working hours.

Fixed

When this is activated, it signals the Activated Charcoal Filter saturation 

alarm, indicating that the filter must be changed; the Metal Grease Filters 

must also be washed. The Activated Charcoal Filter saturation alarm comes 

into operation after the Hood has been working for 200 hours.

Flashing

5. LIGHTING

•  For replacement contact technical 

support (“To purchase contact techni-

cal support”).