specified in the installation instructions for the
appliance or hob.
•
The discharge of air must comply with local authorities
regulations.
•
Ensure good air ventilation in the room where the
appliance is installed to avoid the backflow of
unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
•
Make sure that the ventilation openings are not
blocked and the air collected by the appliance is not
conveyed into a duct used to exhaust smoke and
steam from other appliances (central heating systems,
thermosiphons, water-heaters, etc.).
•
When the appliance operates with other appliances
the maximum vacuum generated in the room should
not exceed 0.04 mbar.
•
Make sure not to cause damage to the mains cable.
Contact our Authorised Service Centre or an
electrician to change a damaged mains cable.
•
If the appliance is connected directly to the power
supply, the electrical installation must be equipped
with an isolating device that allows to disconnect the
appliance from the mains at all poles. Complete
disconnection must comply with conditions specified
in the overvoltage category III. The means for
disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules.
•
Do not flambé under the appliance.
•
Do not use to exhaust hazardous or explosive
materials and vapours.
•
Clean the appliance regularly with a soft cloth to
prevent the deterioration of the surface material.
•
Do not use a steam cleaner, water spray, harsh
abrasive cleaners or sharp metal scrapers to clean the
surface of the appliance. Use only neutral detergents.
•
Clean grease filters regularly (at least every 2 months)
and remove grease deposits from the appliance to
prevent the risk of fire.
www.aeg.com
4
Summary of Contents for DLE0431B
Page 1: ...USER MANUAL EN User Manual Cooker Hood DLE0431B DLE0431W DLE0431M ...
Page 10: ...www aeg com 10 ...
Page 11: ...ENGLISH 11 ...
