AEG DLE0431B, User Manual

The dishwasher must be set

to a low temperature and a

short cycle. The grease filter

may discolour, it has no

influence on the

performance of the

appliance.

5.

To mount the filters back follow the

first two steps in reverse order.

Repeat the steps for all filters if

applicable.

6.2 

Replacing the charcoal

filter

WARNING!

The charcoal filter is non-

washable!

The time of saturation of the charcoal

filter varies depending on the type of

cooking and the regularity of cleaning

the grease filter.
To replace the filter:

1.

Remove the grease filters from the

appliance.

Refer to "Cleaning the grease filter" in

this chapter.

2.

Remove the clips holding the filter

bed, then the filter bed.

3.

To install a new filter, perform the

same steps in reverse order.

In any case, it is necessary to replace the

filters at least every four months.

6.3 

Replacing the lamp

This appliance is supplied with a LED

lamp. This part can be replaced by a

technician only. In case of any

malfunction refer to "Service" in the

"Safety Instructions" chapter.

7. 

TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

7.1 

What to do if...

Problem

Possible cause

Remedy

You cannot activate the ap-
pliance.

The appliance is not connec-
ted to a power supply or it is
connected incorrectly.

Check if the appliance is cor-
rectly connected to the elec-
trical supply.

You cannot activate the ap-
pliance.

The fuse is blown.

Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.

The lamp does not operate.

The lamp is defective.

Replace the lamp. Refer to
the "Care and Cleaning"
chapter

The appliance does not ab-
sorb enough vapours.

The motor speed is not ade-
quate to the appearing va-
pours.

Change the speed of the
motor.

www.aeg.com

8