Themen
49
You can choose from three transmission methods for audio signals.
You must generally choose fi rst whether you would like to have the
sound coming from your TV, or through a Stereo or 5.1-Amplifi er.
The Audio cable must then be connected to the TV or an amplifi er
accordingly.
NOTE:
If your amplifi er is equipped with a digital output, you should use the
amplifi er. You will experience a much better audio quality, and the
installation is much easier.
Stereo
Connect both Audio cables for the right (Fig. 7/1) and the left (Fig. 7/2)
speakers to your replay device or your amplifi er.
1.
Plug the Audio jacks into the sockets on the back of the player.
2.
Plug the Audio jacks into the corresponding sockets on your replay
device or your amplifi er.
5.1-Audio signal
If you would like to achieve a replay of almost original quality you
should use an Audio output by means of a 5.1-Audio signal.
This method uses 6 speakers. Four of these speakers are placed in
the four corners of the room. One speaker is positioned close to the
replay device. The sixth speaker serves the output of very low tones.
With this arrangement of speakers a very natural stereophonic sound
is achieved.
If your amplifi er has no digital input you need six cables to transmit the
analogue 5.1-Audio signal.
Proceed as follows:
1.
Plug the Audio jacks into the sockets on the back of the player.
Make sure that the jacks are correctly arranged:
-
(1) Connection for Subwoofer: Bass
-
(2) Connection for Center speaker
-
(3) Speaker rear right
-
(4) Speaker rear left
-
(5) Speaker front right
-
(6) Speaker front left
2.
Plug the Audio jacks into the corresponding sockets on your replay
device or your amplifi er.
Connecting the
Audio cable
Fig. 7
Fig. 8
Starting up
2
1
6
5
1
4
3
2
05-DVD 4517 AEG - GB 49
19.01.2006, 10:52:51 Uhr
