46
Themen
You can choose from three transmission methods for audio signals.
You must generally choose fi rst whether you would like to have the sound
coming from your TV, or through a Stereo or 5.1-Amplifi er. The Audio cable
must then be connected to the TV or an amplifi er accordingly.
NOTE:
If your amplifi er is equipped with a digital output, you should use the
amplifi er. You will experience a much better audio quality, and the installation
is much easier.
Stereo
Connect both Audio cables for the right and the left speakers to your playback
device or your amplifi er.
1.
Plug the Audio jacks into the sockets on the back of the player.
2.
Plug the Audio jacks into the corresponding sockets on your playback
device or your amplifi er.
5.1-Audio signal
It is possible to obtain a particularly natural surround sound effect by means of
audio output through a 5.1 audio signal.
This method uses 6 speakers. Four of these speakers are placed in the four
corners of the room. One speaker is positioned close to the playback device.
The sixth speaker serves the output of very low tones. With this arrangement
of speakers a very natural stereophonic sound is achieved.
Connect the 5.1CH AUDIO OUT sockets on the back of the DVD player to the
corresponding connections on the back of the subwoofer.
Proceed as follows:
1.
Plug the Audio jacks into the sockets on the back of the player. Make sure
that the jacks are correctly arranged:
- (1) Connection for Subwoofer: Bass
- (2) Connection for Center speaker
- (3) Speaker rear right
- (4) Speaker rear left
- (5) Speaker front right
- (6) Speaker front left
2.
Plug the Audio jacks into the corresponding sockets on your playback
device or your amplifi er.
Connecting the Audio cable
Fig. 2/9
Fig. 2/8
Starting up
05-DVD 4525 AEG - GB 46
24.04.2007, 15:41:51 Uhr
