ENGLISH
23
Important Information on the Optical Output and
Coaxial Output
• Only
amplifi ers with decoders for DOLBY DIGITAL,
DTS and MPEG may be connected to the coaxial
output. If other amplifi ers are used this may cause
damage to the loudspeakers or even the listener‘s
ears due to the high level of noise.
• Choose the setting “RAW” in the DIGITAL AUDIO
SETUP if you are using the coaxial output or the
optical output.
If you select the option PCM for the digital output signal,
the player converts the standard sampling rate of 96 kHz
at the coaxial output to 48 kHz. For the RAW mode you
can set a sampling rate of 48 kHz.
Note: For detailed information on setting the audio
output signal, please refer to the operating instructions
at the back of the manual.
E: Technical Information
• Dolby Digital is a digital sound compression techni-
que developed by the Dolby Laboratories Licensing
Corporation. The data compression enables large
sound data fi les to be stored on disks.
• Linear PCM is a signal-recording format used for
CDs. While CDs are recorded with a sampling rate
of 44.1 KHz and a resolution of16 bits, DVDs use a
sampling rate of between 48 KHz/16 bits and 96 KHz
/24 bits.
PREPARING THE REMOTE CONTROL
F: Inserting the Batteries
Ensure that the batteries are inserted the right way round
(see Illustration A).
Service Life of the Batteries
• The batteries normally last for at least one year,
although this depends on the extent to which the
remote control is used.
• If the player fails to respond to the remote control
even if it is held in the immediate vicinity of the play-
er, the batteries need to be replaced.
• Use two batteries of size AAA (UM-4).
Note:
• Do not use rechargeable (Ni-Cd) batteries.
• Do not attempt to recharge, short circuit, disas-
semble, heat or throw the batteries into a fi re.
• Do not drop, step on or damage the remote control in
any other way.
• When inserting a new pair of batteries, please ensure
that the two batteries have the same date of manuf-
acture and have not been used before
• If the remote control is not going to be used for a
prolonged period please remove the batteries as
otherwise electrolyte may leak out. This may lead not
only to malfunctioning, but also to an internal short
circuit.
• Any electrolytic fl uid which has leaked out must be
removed immediately. The batteries should also be
replaced.
• If any electrolyte should come into contact with parts
of your body, wash it off immediately with water.
G: Remote Control Operating Range
• The remote control should not be positioned more
than 5 m from the player and at an angle of not more
than 2 x 30 degrees to the player.
• The maximum operating distance may vary accor-
ding to the brightness of the room.
Note:
• Do not point any bright lights at the remote control
sensor on the player.
• Do not place any objects between the remote control
and the remote control sensor.
• Do not use the remote control while simultaneously
operating the remote control of other equipment.
Receiver sensor
Maximum 5 metres
Dust protection cap
Dust protection cap
5....-05-DVD 4602 AEG D_GB 23
16.03.2004, 12:16:24 Uhr
