32
When the carbon filters need replacing,
an acoustic signal is issued for some
seconds and the led point above the
light push button keeps on flashing.
7.2.3. TO PUT THE GREASE AND CARBON FILTERS CONTROL BACK TO ZERO
To put the grease filter counter back to zero you must:
•
stop the motor;
•
press the timer push button twice in succession, until you hear the acoustic signal.
To confirm reset the led point stops flashing.
To put the carbon filter counter back to zero you must:
•
stop the motor;
•
press the light push button twice in succession until you hear the acoustic signal.
To confirm reset, the led point stops flashing.
ATTENTION: The light push button does not switch on/off the lights until you hear
acoustic signal.
7.2.4 SETTING OF THE SUCTION/FILTERING USE OF THE HOOD
The hood is delivered standard for suction use.
If you wish to use the hood in the filtering version, proceed as follows:
•
disconnect hood from electricity and then reconnect this to electricity;
•
the led-point of the light push button will flash for approx. 10 seconds. During this time
press the light push button 3 times. Three acoustic signals are issued to point out the new
setting.
ATTENTION: during the suction/filtering setting phase no function can be
activated.
If the hood is set for suction, when connected the led point over the LIGHT Push Button
is flashing. If the hood is set for filtering, when connected the led point over the
TIMER Push Button is flashing.
8 MAINTENANCE
8.1 CLEANING OF GREASE FILTERS
The metallic grease filters are positioned on the bottom of the hood and are used to contain
any grease which is normally emitted in cooking fumes, thereby impeding the deterioration of
the motor.
For washing by hand, use hot water and soap; this can be done by hand brushing vigorously
several times and then rinsing under the tap.
After washing, the grease filters should be dried and re-fitted correctly.
It is possible that after washing the filter colour changes slightly.
In this paragraph guide lines are given, which should be complied with.
WARNING !
We recommend washing grease filters after 50-100 hours of use of the hob
. If grease
filters are dirty, motor can take in just a small quantity of air and performance is reduced;
The grease which accumulates on dirty filters is easily inflammable and
CAN CAUSE
FIRES,
if not eliminated by periodic washes.
The manufacturer declines any responsibility for fires caused by poor maintenance
of the grease filters.
8.2 CARBON FILTERS
The carbon filters at the suction outlet of the motor, are used to retain the odours of kitchen
fumes. It is not necessary to use carbon filters, if the hood is used for suction use.
The use of carbon filters is necessary if you use the hood as filtering.
Summary of Contents for ELECTROLUX EFC9740.2X
