AEG ESF97400RKX, User Manual

Problem and alarm code

Possible solution

The anti-flood device is on.
The display shows 

.

• Close the water tap.

• Make sure that the appliance is correctly installed.

• Make sure the baskets are loaded as instructed in the

user manual.

The appliance stops and

starts more times during op‐

eration.

• It is normal. It provides optimal cleaning results and en‐

ergy savings.

The program lasts too long.

• If the delayed start option is set, cancel the delay setting

or wait for the end of the countdown.

• Activating options can increase the programme duration.

The displayed program du‐

ration is different than the

duration in the consumption

values table.

• The pressure and the temperature of the water, the var‐

iations of the mains supply, the options, the quantity of

dishes and the degree of soil can change the program

duration.

The remaining time in the

display increases and skips

nearly to the end of program

time.

• This is not a defect. The appliance is working correctly.

Small leak from the appli‐

ance door.

• The appliance is not levelled. Loosen or tighten the ad‐

justable feet (if applicable).

• The appliance door is not centred on the tub. Adjust the

rear foot (if applicable).

The appliance door is diffi‐

cult to close.

• The appliance is not levelled. Loosen or tighten the ad‐

justable feet (if applicable).

• Parts of the tableware are protruding from the baskets.

The appliance door opens

during the wash cycle.

• The AirDry function is activated. You can deactivate the

function. Refer to "Settings".

Rattling/knocking sounds

from inside the appliance.

• The tableware is not properly arranged in the baskets.

Refer to basket loading leaflet.

• Make sure that the spray arms can rotate freely.

The appliance trips the cir‐

cuit-beaker.

• The amperage is insufficient to supply simultaneously all

the appliances in use. Check the socket amperage and

the capacity of the meter or turn off one of the applian‐

ces in use.

• Internal electrical fault of the appliance. Contact an Au‐

thorised Service Centre.

Refer to "Before first use", 

"Daily use", or "Hints and

tips" for other possible

causes.

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.
For alarm codes not described in the

table, contact an Authorised Service

Centre.

ENGLISH

21