ENGLISH
32
General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser“ for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
Controls
1 CD compartment
2 I
PREV key (reverse search)
3
I NEXT key (forward search)
4
STOP/off key
5
/ II PLAY/PAUSE play/pause key
6 MODE key
7 PROG key (CD programming)
8 ESP/ALBUM key
9 LCD display
10 HOLD OFF/ON key lock
11 OPEN CD compartment
12 DC 4,5V connection for mains adapter
13 LINE OUT socket
14 BASS BOOST ON/OFF switch
15 VOLUME / volumecontrol
16
PHONES headphone connection
17 CHARGE ON/OFF switch
18 Battery compartment
Headphone - Remote Control
A Headphone connection
B
/ II play/pause
C
stop/off
D I
(reverse search)
E
I (forward search)
F Volumecontrol
G HOLD key lock
Note: Some keys are to be found both on the device
itself and on the remote control. Keys with the same
designation have the same function.
In order to use the headphone remote control, please
proceed as follows:
• Connect the plug of the headphone remote control to
the socket (16) on the device and then insert the plug
of the headphones/earphones into the connection
socket (A).
• Attach the remote control with the help of the clip,
e.g. to the lapel of a jacket etc.
Commissioning the device
CD deck transport protection
• Shift the OPEN key (11) to the right to open the CD
compartment (1).
• Remove the transport protection from the CD player
if present before use.
Battery Mode (not supplied)
• Open the battery compartment (18) on the inside of
the machine.
• Insert 2 1,5 V AA type batteries. Match the polarities
correctly (see the inside of the battery compartment).
• Close the battery compartment.
• A battery symbol in the display indicates that the
batteries need to be replaced. Always replace a
complete set of batteries and not just one.
• If the device is not used for a prolonged period,
please remove the batteries in order to avoid the
leakage of battery acid.
5....-05-CDP 4202 MP3 AEG 32
06.09.2004, 12:47:51 Uhr
