Manual adjustment
Turn the water hardness dial to the posi-
tion 1 or 2.
Electronic adjustment
1.
Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
‘SETTING AND STARTING A PRO-
GRAMME’.
2.
Press and hold touchpads (
4
) and (
5
)
at the same time until the indicators
of touchpads (
3
), (
4
) and (
5
) flash.
3.
Press touchpad (
3
).
• The indicators of touchpads (
4
)
and (
5
) go off.
• The indicator of touchpad (
3
) con-
tinues to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the setting of
the water softener, e.g.
= level
5.
4.
Press touchpad (
3
) again and again
to change the setting.
5.
Deactivate the appliance to confirm
the setting.
6.2
Filling the salt container
1.
Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
3.
Fill the salt container with dishwash-
er salt.
4.
Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
26 www.aeg.com
