6.
Assemble the filter (
A
) and put it in-
to position in filter (
B
). Turn it clock-
wise until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
9.2
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.
9.3
External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
10.
TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
With some problems, an intermittent
acoustic signal operates and the dis-
play shows a message.
WARNING!
Deactivate the appliance before
you do the checks.
Problem
Possible cause
Possible solution
The programme
does not start.
The mains plug is not con-
nected in the mains socket.
Connect the mains plug.
The appliance door is
open. (The display shows a
message).
Close the appliance door.
You did not press the start
touchpad.
Press the start touchpad.
The fuse in the fuse box is
damaged.
Replace the fuse.
The delay start is set.
Cancel the delay start or
wait for the end of the
countdown.
34 www.aeg.com
