7.1
XtraDry
Activate this option to boost the drying
performance.
XtraDry is a permanent option for all
programmes other than
. It is
automatically activated in next cycles.
This configuration can be changed at any
time.
Every time
is
activated, XtraDry is off and
needs to be chosen
manually.
Activating XtraDry deactivates TimeSaver
and vice versa.
How to activate XtraDry
Press
Option
until the indicator
is on.
The display shows the updated
programme duration.
7.2
TimeSaver
The TimeSaver allows to reduce the
duration of a selected programme by
approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
By default, TimeSaver is off, but it is
possible to activate it manually. This
option cannot be combined with
XtraDry.
How to activate TimeSaver
Press
Option
until the indicator
is on.
The display shows the updated
programme duration.
7.3
ExtraHygiene
This option provides better hygiene
results by keeping the temperature at 70
°C for at least 10 minutes during the last
rinsing phase.
How to activate ExtraHygiene
Press
Option
until the indicator
is on.
The display shows the updated
programme duration.
8.
BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2.
Fill the salt container.
3.
Fill the rinse aid dispenser.
4.
Open the water tap.
5.
Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
After starting a programme, it may take
up to 5 minutes for the appliance to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure is repeated periodically.
8.1
The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1.
Turn the cap of the salt container
counterclockwise and remove it.
2.
Put 1 litre of water in the salt
container (only for the first time).
ENGLISH
37