9.2 Setting and starting a
programme
The Auto off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was
not started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode and the door is closed.
2. Press Program again and again until
the indicator of the desired
programme is on.
The display shows the programme
duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running phase
is on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay repeatedly until the
display shows the desired delay time
(from 1 to 24 hours).
3. Press Start to begin the countdown.
• The indicator is on.
• The remaining time counts down
in hours. The final hour is
displayed in minutes.
When the countdown is completed, the
programme starts and the indicator of the
running phase is on. The indicator is
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Do not try to close the
appliance door within 2
minutes after AirDry
automatically opens it as this
may cause damage to the
appliance.
If, afterwards, the door is
closed for at least 3 minutes,
the running programme
ends.
Cancelling the delay start
while the countdown
operates
When you cancel the delay start you
have to set the programme and options
again.
Press simultaneously Delay and Option
until the appliance is in programme
selection mode.
Cancelling the programme
Press and hold simultaneously Delay
and Option until the appliance is in
programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is complete, the
Auto off function switches the appliance
off automatically.
All buttons are inactive except for the
on/off button.
Close the water tap.
www.aeg.com
16
