Problem and alarm code
Possible cause and solution
The appliance trips the cir‐
cuit-beaker.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian‐
ces in use.
• Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
WARNING!
We do not recommend using
the appliance until the
problem has been
completely fixed. Unplug the
appliance and do not plug it
in again until you are certain
that it operates correctly.
12.1 The dishwashing and drying results are not satisfactory
Problem
Possible cause and solution
Poor washing results.
• Refer to "Daily use", "Hints and tips" and the basket
loading leaflet.
• Use more intensive washing programme.
• Activate the ExtraPower option to improve the washing
results of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
Poor drying results.
• Tableware was left for too long inside the closed appli‐
ance. Activate the function AirDry to set the automatic
opening of the door and to improve the drying perform‐
ance.
• There is no rinse aid or the dosage of rinse aid is not
sufficient. Fill the rinse aid dispenser or set the dosage
of rinse aid to a higher level.
• The quality of the rinse aid can be the cause.
• Always use rinse aid, even with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase. Re‐
fer to "Programmes overview".
There are whitish streaks or
bluish layers on glasses and
dishes.
• The released quantity of rinse aid is too high. Adjust
the rinse aid dosage to a lower level.
• The quantity of detergent is too high.
ENGLISH
23
