setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously
and
for
about 3 seconds.
• The light related to and the
indicator flash.
• The indicators , ,
and
are on.
• The lights related to MY TIME
selection bar are on.
How to navigate in setting
mode
You can navigate in setting mode using
MY TIME selection bar.
B
A
C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to change a setting
Make sure the appliance is in setting
mode.
1. Press Previous or Next until the
indicator dedicated to the desired
setting flashes.
The light related to indicates the
current setting value:
• For the settings with two values
(on and off), the light is either on
(= the setting is on) or off (= the
setting is off).
• For the settings with multiple
values (levels), the light flashes.
The number of flashes indicates
the current setting value (e.g. 5
f pause + 5 flashes... =
level 5).
2. Press OK to enter the setting.
• The indicator related to the setting
is on.
• The other indicators are off.
• The light related to indicates
the current setting value.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the
setting selection.
5. Press and hold simultaneously
and
for about 3
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30min to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
www.aeg.com
12
