Use
Previous
and
Next
to switch
between the basic settings and to
change their value.
Use
OK
to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously
and
for
about 3 seconds.
The lights related to the
Previous
,
OK
and
Next
are on.
How to change a setting
Make sure the appliance is in setting
mode.
1.
Use
Previous
or
Next
to select the
bar of the ECOMETER dedicated to
the desired setting.
• The bar of the ECOMETER
dedicated to the chosen setting
flashes.
• The display shows the current
setting value.
2.
Press
OK
to enter the setting.
• The bar of the ECOMETER
dedicated to the chosen setting is
on. The other bars are off.
• The current setting value flashes.
3.
Press
Previous
or
Next
to change
the value.
4.
Press
OK
to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5.
Press and hold simultaneously
and
for about 3
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7.
BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2.
Fill the salt container.
3.
Fill the rinse aid dispenser.
4.
Open the water tap.
5.
Start the programme Quick to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
7.1
The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1.
Turn the cap of the salt container
counterclockwise and remove it.
2.
Put 1 litre of water in the salt
container (only for the first time).
3.
Fill the salt container with dishwasher
salt (until it is full).
ENGLISH
13
