• The indicator
still flashes.
• The display shows the current
setting: e.g.
= level 5.
2.
Press
repeatedly to change the
setting.
3.
Press on/off to confirm the setting.
6.3
The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1.
Press
.
• The indicators
,
,
,
and
are off.
• The indicator
still flashes.
• The display shows the current
setting.
–
= the rinse aid empty
notification is deactivated.
–
= the rinse aid empty
notification is activated.
2.
Press
to change the setting.
3.
Press on/off to confirm the setting.
6.4
The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1.
Press
.
• The indicators
,
,
,
and
are off.
• The indicator
continues to
flash.
• The display shows the current
setting: e.g.
= level 4.
– The levels of rinse aid range
from 0A to 6A where level 0A
means rinse aid is not used.
2.
Press
repeatedly to change the
setting.
3.
Press on/off to confirm the setting.
6.5
Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
Make sure the appliance is in user mode.
1.
Press
.
• The indicators
,
,
,
and
are off.
• The indicator
still flashes.
• The display shows the current
setting.
–
= the acoustic signal is
deactivated.
–
= the acoustic signal is
activated.
2.
Press
to change the setting.
3.
Press on/off to confirm the setting.
www.aeg.com
36
Summary of Contents for FSE83700P
Page 75: ...FRANÇAIS 75 ...