AEG FSK73677P, User Manual

Water softener lev‐

el

Amount of water

(l)

9

3

10

3

In case of the high water softener setting,

it may occur also in the middle of the

programme, before the rinse (twice

during a programme). Regeneration

initiation has no impact on the cycle

duration, unless it occurs in the middle of

a programme or at the end of a

programme with a short drying phase. In

that cases, the regeneration prolongs the

total duration of a programme by

additional 5 minutes.
Subsequently, the rinsing of the water

softener that lasts 5 minutes may begin

in the same cycle or at the beginning of

the next programme. This activity

increases the total water consumption of

a programme by additional 4 litres and

the total energy consumption of a

programme by additional 2 Wh. The

rinsing of the softener ends with a

complete drain.
Each performed softener rinse (possible

more than one in the same cycle) may

prolong the programme duration by

another 5 minutes when it occurs at any

point at the beginning or in the middle of

a programme.

All the consumption values

mentioned in this section are

determined in accordance

with the currently applicable

standard in laboratory

conditions with water

hardness 2.5mmol/L

according to the 2019/2022

regulation (water softener:

level 3).

The pressure and the

temperature of water as well

as the variations of the

mains supply can change

the values.

6.3 Rinse aid level

The rinse aid helps to dry the dishes

without streaks and stains. It is

automatically released during the hot

rinse phase. It is possible to set the

released quantity of rinse aid.
When the rinse aid dispenser is empty,
the display shows the indicator   and 

Rinse aid low. If the drying results are

satisfactory while using multi-tablets only,

it is possible to deactivate the dispenser

and the refill notification. However, for

best drying performance, always use

rinse aid and keep the notification active.
To deactivate the rinse aid dispenser and

the notification, set the rinse aid level to

0.

6.4 End sound

You can activate an acoustic signal that

sounds when the programme is

completed.

Acoustic signals sound also

when a malfunction of the

appliance occurs. It is not

possible to deactivate these

signals.

6.5 AirDry

AirDry improves the drying results. The

appliance door opens automatically

during the drying phase and remains

ajar.

AirDry is automatically activated with all

programmes.

ENGLISH

13