AEG FSK73677P, User Manual

Problem and alarm code

Possible cause and solution

You cannot activate the ap‐

pliance.

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that there is no damaged fuse in the fuse

box.

The programme does not

start.

• Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance recharges the resin inside the water soft‐

ener. The duration of the procedure is approximately 5

minutes.

The appliance does not fill

with water.
The display shows  , Error

i10 or Error i11 and No in‐

take of water.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not

drain the water.
The display shows  , Error

i20 and Water is not drain‐

ing.

• Make sure that the sink spigot is not clogged.

• Make sure that the interior filter system is not clogged.

• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.
The display shows  , Error

i30 and Risk of flood de‐

tected.

• Close the water tap and contact an Authorised Service

Centre.

Malfunction of the water lev‐

el detection sensor.

The display shows i41 - i44.

• Make sure that the filters are clean.

• Switch the appliance off and on.

Malfunction of the wash

pump or the drain pump.

The display shows i51 - i59

or i5A - i5F.

• Switch the appliance off and on.

The temperature of the wa‐

ter inside the appliance is

too high or malfunction of

the temperature sensor oc‐

curred.

The display shows i61 or 

i69.

• Make sure that the temperature of the inlet water does

not exceed 60°C.

• Switch the appliance off and on.

www.aeg.com

24