Problem
Possible cause and solution
Traces of rust on cutlery.
• There is too much salt in the water used for washing.
Refer to
"The water softener"
.
• Silver and stainless steel cutlery were placed together.
Avoid to put silver and stainless steel items close to-
gether.
There are residues of deter-
gent in the dispenser at the
end of the programme.
• The detergent tablet got stuck in the dispenser and
therefore was not completely washed away by water.
• Water cannot wash away the detergent from the dis-
penser. Make sure that the spray arm is not blocked or
clogged.
• Make sure that items in the baskets do not impede the
lid of the detergent dispenser from opening.
Odours inside the appliance.
• Refer to
"Internal cleaning"
.
Limescale deposits on the ta-
bleware, on the tub and on
the inside of the door.
• The level of salt is low, check the refill indicator.
• The cap of the salt container is loose.
• Your tap water is hard. Refer to
"The water softener"
.
• Even using multi-functional tabs use salt and set re-
generation of the water softener. Refer to
"The water
softener"
.
• If lime scale deposits still remain, clean the appliance
with appliance cleaners which are particularly suitable
for this purpose.
• Try different detergent.
• Contact the detergent manufacturer.
Dull, discoloured or chipped
tableware.
• Make sure that only dishwasher-safe items are washed
in the appliance.
• Load and unload the basket carefully. Refer to basket
loading leaflet.
• Place delicate items in the upper basket.
Refer to
"Before first use"
,
"Daily use"
or
"Hints and
tips"
for other possible
causes.
13.
TECHNICAL INFORMATION
Dimensions
Width / height / depth (mm)
596 / 818-898 / 550
Electrical connection
1)
Voltage (V)
220 - 240
Frequency (Hz)
50
Water supply pressure
bar (minimum and maximum)
0.5 - 8
MPa (minimum and maximum)
0.05 - 0.8
www.aeg.com
22
