AEG HC411521GB, User Manual

The manufacturer refuses

to be held responsible, if

these safety measures are

not abided by.

Supply connections

This hob has to be connected to 220-240

V (~ 50-60 Hz ) electricity supply.

The hob has a terminal block which is

marked as follows:

•

L

 — Live terminal

•

N

 — Neutral terminal

•

 or 

E

 — Earth terminal

Before carrying out the connection,

make sure:

1.

The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2.

The supply system is equipped with

an efficient earth connection in

compliance with the current

standards and regulations

3.

The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

The appliance is supplied with a 3 core

flexible power cable.
The wires in the cord are coloured as

follows:

Green and yellow

- Earth

Blue

- Neutral

Brown

- Live

WARNING!

A cut off plug inserted into a

13 amp socket is a serious

shock hazard. Ensure that

the cut off plug is disposed

of safely.

3.7 

Replacement of the

connection cable

The replacement of electric

cable must be carried out

exclusively by the service

force centre or by personnel

with similar competencies, in

accordance with the current

regulations.

To replace the connection

cable use only H03V2V2-F

T90 or equivalent type.

Make sure that the cable

section is applicable to the

voltage load and the

working temperature. The

yellow/green earth wire (B)

must be approximately 2 cm

longer than the live and

neutral wire (A).

A

B

1.

Connect the green and yellow (earth)

wire to the terminal which is marked

with the letter 'E', or the earth
symbol  , or coloured green and

yellow.

2.

Connect the blue (neutral) wire to the

terminal which is marked with the

letter 'N' or coloured blue.

3.

Connect the brown (live) wire to the

terminal which is marked with the

letter 'L'. It must always be

connected to the network phase.

There must be no cut or stray strands

of wire present. The cord clamp must

be correctly attached to the outer

sheath.

www.aeg.com

10