AEG HC411521GB, User Manual

3.4 

Injectors replacement

WARNING!

The injector kit for gas

replacement is not provided.

Please call the Authorized

Service Center.

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in

"Technical Data" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

3.5 

Adjustment of minimum

level

To adjust the minimum level of the

burners:

1.

Light the burner.

2.

Turn the knob on the minimum

position.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

bypass screw position (A).

A

5.

If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

3.6 

Electrical connection

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of

fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the appliance beneath the

cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a

contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

ENGLISH

9