• Install anti-shock protection, for example install the drawers only with a protective panel
directly below the appliance!
• Prevent damage of the cut surfaces of the worktop against moisture with a correct seal
-
ant!
• Seal the appliance to the worktop with no space left with a correct sealant!
• Prevent damage of the bottom of the appliance from steam and moisture, e.g. from a
dishwasher or oven!
• Do not install the appliance adjacent to doors and below windows! If not, hot cookware
can be hit off the hob when you open doors or windows.
•
Disconnect the appliance from the electrical supply, before you do maintenance
work or clean.
WARNING!
Risk of injury from electrical current. Carefully obey the instructions for electrical connec
-
tions.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connections can make the terminal become
too hot.
• A qualified electrician must install the clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the damaged mains cable with prop
-
er special cable. Speak your local Service Force Centre.
• The appliance must have the electrical installation which lets you disconnect the appli
-
ance from the mains at all poles with a contact opening width of minimum 3 millime
-
tres.
• If the fixing bracket is near to the terminal block, always make sure the connection cable
does not come in contact with the edge of the bracket.
• You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses
removed from the holder), ground leakage trips and contactors.
Manufacturer is not responsible for any injury to persons and pets or damage to prop-
erty caused by failure to obey these requirements.
Electrical connection
• Ground the appliance according to safety precautions.
• Make sure that the rated voltage and type of power on the rating plate agree with the
voltage and the power of the local power supply.
• Any electrical component must be installed or replaced by the Service Force Centre tech
-
nician or qualified service personnel.
• Always use a correctly installed shockproof socket.
• Make sure that there is an access to the mains plug after installation.
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
18
Installation