3.4
OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/ / There is a risk of
burns from residual heat.
The indicator shows the level
of the residual heat. When
the hob is hot and the
residual heat indicator is
shown, flexibridge and cross
lines on the hob surface light
up.
The induction cooking zones make the
heat necessary for cooking process
directly in the bottom of the cookware.
The glass ceramic is heated by the heat
of the cookware.
4.
DAILY USE
WARNING!
Refer to Safety chapters.
4.1
Activating and
deactivating
Touch for 1 second to activate or
deactivate the hob.
The control panel comes on after you
activate the hob and goes off after you
deactivate the hob. When the hob is
deactivated you can see only sensor
field.
4.2
Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the
hob again.
• you use incorrect cookware. The
symbol comes on and the cooking
zone deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone
or change the heat setting. After
some time comes on and the hob
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
The hob deacti-
vates after
, 1 - 3
6 hours
4 - 7
5 hours
8 - 9
4 hours
10 - 14
1.5 hour
4.3
The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
ENGLISH
9
