AEG IKE85451IB, User Manual

3. INSTALLATION

WARNING!

Refer to Safety chapters.

3.1 Before the installation

Before you install the hob, write down the

information below from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

3.2 Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

3.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable, use

the cable type: H05V2V2-F which

withstands a temperature of 90 °C or

higher. Contact an Authorised Service

Centre. The connection cable may only be

replaced by a qualified electrician.

3.4 Attaching the seal - Integrated

installation

1. Clean the rabbets in the worktop.

2. Cut the supplied 3x10mm seal stripe into

4 stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an angle of

45°. They should fit in the corners of the

rabbets accurately.

4. Attach the stripes to the rabbets. Do not

stretch the stripes. Do not bond the ends

of the stripes one over the other.

After you assemble the hob, seal the

remaining gap between the glass ceramic

and the worktop with silicone. Make sure the

silicone does not get under the glass

ceramic.

3.5 Assembly

If you install the hob under a hood, please

see the installation instructions of the hood

for the minimum distance between the

appliances.

min.
50mm

min.
500mm

If the appliance is installed above a drawer,

the hob ventilation can warm up the items

stored in the drawer during the cooking

process.

ENGLISH

7