AEG IKE95751FB, User Manual

8. CARE AND CLEANING

WARNING!

Refer to Safety chapters.

8.1 General information

• Clean the hob after each use.

• Always use cookware with a clean base.

• Scratches or dark stains on the surface

have no effect on how the hob operates.

• Use a special cleaner suitable for the

surface of the hob.

• Use a special scraper for the glass.

8.2 Cleaning the hob

• Remove immediately: melted plastic,

plastic foil, salt, sugar and food with

sugar, otherwise, the dirt can cause

damage to the hob. Take care to avoid

burns. Use a special hob scraper on the

glass surface at an acute angle and move

the blade on the surface.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat

stains, shiny metallic discoloration. Clean

the hob with a moist cloth and a non-

abrasive detergent. After cleaning, wipe

the hob dry with a soft cloth.

• Remove shiny metallic discoloration:

use a solution of water with vinegar and

clean the glass surface with a cloth.

9. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

9.1 What to do if...

Problem

Possible cause

Remedy

You cannot activate or operate

the hob.

The hob is not connected to an elec‐

trical supply or it is connected incor‐

rectly.

Check if the hob is correctly connected

to the electrical supply.

The fuse is blown.

Make sure that the fuse is the cause of

the malfunction. If the fuse is blown

again and again, contact a qualified

electrician.

You do not set the heat setting for

60 seconds.

Activate the hob again and set the

heat setting in less than 60 seconds.

You touched 2 or more sensor fields

at the same time.

Touch only one sensor field.

Pause operates.

Refer to "Daily use".

There is water or fat stains on the

control panel.

Clean the control panel.

You can hear a constant beep

noise.

The electrical connection is incor‐

rect.

Disconnect the hob from the electrical

supply. Ask a qualified electrician to

check the installation.

ENGLISH

17