5.8 Bridge
If you place cookware on two or more
standard cooking zones and the heat
setting level is set to 0, appears.
If the default configuration is not
appropriate for your cookware, press
repeatedly to choose the desired
configuration manually.
The following modes are available:
• Centre
• Vertical
• Horizontal
• Standard cooking zone
The cooking zone indicators change
automatically to show the possible
combination.
All single triangles of one mode are
controlled by one control bar which lights
up.
When you change the heat setting,
disappears. When the heat setting is set
to 0, comes on again.
5.9 PowerBoost
This function activates more power for
the appropriate induction cooking zone,
depending on the cookware size. The
function can be activated only for a
limited period of time.
It is not possible to use the function when
Bridge is activated in the Centre, Vertical
or Horizontal mode.
To activate the function for the
cooking zone: touch . The symbol
turns red.
The function deactivates automatically.
For maximum duration
values, refer to "Technical
data".
5.10 Timer
•
Count Down Timer
You can use this function to set the
length of a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To activate the function or change the
time: touch . The timer digits 00 and
the indicators and light up on the
display. turns red, and turns white.
If the timer is not set, all
indicators disappear after 3
seconds.
Touch or to set the time (00 - 99
minutes). After 3 seconds, the timer
starts to count down automatically. The
indicators , , and disappear.
stays red.
When the timer finishes counting down, a
signal sounds and 00 flashes. To stop
the signal, touch .
To deactivate the function: touch .
The indicators and light up. Use
or to set 00 on the display.
Alternatively, set the heat level to 0. As a
result, a signal sounds and the timer is
cancelled.
•
CountUp Timer
You can use this function to monitor how
long a cooking zone operates.
www.aeg.com
14
