37
ENGLISH
NOTE:
Depending on the software version of your iPhone the
following error message may be displayed:
“This accessory was not developed for iPhone use. It
is possible that noise occurs and signal strength is
reduced.”
In this case press “OK”.
General Operation
NOTE:
Some buttons you can find as well on the device as on
the remote control.
Identical buttons effect the same function.
Switch device on/off
• To turn the device on, set the main switch POWER on
the back of the device to “ON”.
• Press the button (8/21) to toggle the device be-
tween standby and operating mode. In standby mode
the standby indicator (1) turns on.
• To turn the device off, set the main switch POWER on
the back of the device to “OFF”.
NOTE:
The station presets and the latest settings (source,
volume) are deleted when switching the device off.
Volume
By pressing the VOL+/VOL- buttons (5/9/13) you can
adjust the desired volume.
Infrared Remote Control
For wireless control within a distance of 5m. If the
distance decreases you should change the batteries. For
proper operation mind a clear view between the remote
control and the sensor on the device.
Sound Settings (on RC)
• Press the TREB+/TREB- buttons (8/15) to set the treble
value.
• Press the SUB+/SUB- buttons (10/12) to set the bass
value.
NOTE: During iPod/iPhone Music Playback
For optimum sound, change the EQ setting on your
iPod/iPhone as required.
(1 on RC)
For immediate muting of the volume. The Volume display
flashes. Press again to cancel the function.
Radio Tuning
• Press the button (8/21) to switch the device on.
• Press the FM button (2 on RC).
• Tune the program by pressing the / buttons (5).
• If the reception is too weak and there is interfer-
ence on the channel, try to improve the reception by
changing the position of the aerial and /or coil/uncoil
it.
NOTE:
Press the ST/MO button to toggle to mono if the
reception is noisy.
Save Radio Station
1. Press the MEM button (19) to save the station to the
presets. A preset flashes on the display (e.g. P01).
2. Press the /STATION- buttons (4) to select a
station preset between P01 and P20.
3. Briefly press the MEM button to save the radio station.
NOTE:
The station presets and the latest settings (source,
volume) are deleted when disconnecting the device
from mains power supply.
Recall Saved Radio Stations
Press the /STATION- buttons (4) to access the
station presets.
Music Playback from iPod/iPhone
(iPod/iPhone not supplied)
CAUTION:
Before plugging in the iPod/iPhone, make sure that the
radio is
not
in iPod/iPhone mode.
1. Insert the adapter supplied with your iPod into the
dock. You can only ensure that the iPod fits correctly
into the iPod port if the adapter is plugged in.
2. Insert your iPod/iPhone into the dock.
CAUTION:
Make sure that your iPod/iPhone is plugged upright
into the port. Do not bend or tilt the iPod/iPhone
whilst it is plugged into the port. This may cause
damage to the dock or the iPod/iPhone.
3. Press the button (8/21) to switch the device on.
Repeatedly press the MODE button (4 on device) until
“iPod” is displayed.
NOTE:
Alternatively press the iPOD button (20 on RC) to
select iPod mode.
