35
Heavy build up of frost, pos-
sibly also on the door seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 °C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
Malfunction
Possible Cause
Remedy
The freezer temperature is
not sufficient, red light lights
up, temperature signal
sounds
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial
Start Up" section.
Press the fast freeze switch
Door was open for an exten-
ded period.
Please look in the "Installa-
tion location" section.
Disturbance on the applian-
ce
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
Open the door only as long
as necessary.. Press the
fast freeze switch
Unusual noises.
The appliance is touching
the wall or other objects.
Appliance is not level.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
The compressor starts after
a period of time.
This is normal, no error has
occurred.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
If necessary, carefully bend
the component out of the
way.
Move the appliance slightly.
Readjust the feet.
