15
www.aeg.com
NL
BG
FR
DE
GR
PT
ES
AR
EN
13
The automatic switch off function.
When the water has boiled or the kettle is moved from the base, it will switch off automati
-
cally.
If you wish to stop it in the middle of the heating/keeping warm process, simply press the START or KEEP WARM/
TURBO button again.
The white LED light on the START or KEEP WARM/TURBO button indicates it’s in working progress.
14
When the kettle is lifted up off and put back on the base, the display will show the real time water temperature and
turns off/black after 5 minutes.
CLEANING AND CARE
15
Before cleaning, always unplug the appliance.
Never rinse or immerse the kettle or base unit in water. Just wipe with a
damp cloth, using no abrasive detergents. Occasionally rinse out the kettle with clean water.
16
To clean the mesh filter,
grab the strainer insert and lift out.
Cleaning the heating plate
– superficial spots of rust may ap
-
pear on the base unit. Remove with a stainless steel cleaning agent.
17
Decalcifying
is recommended regularly, depending on water hardness. Fill the kettle with water and decalcifier according to
decalcifier product instructions. Do not boil the solution as it may foam over. Afterwards, rinse kettle thoroughly with fresh
water.
Enjoy your new AEG product!
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The appliance switches off before
boiling.
Too much lime scale at the base of the
kettle.
Run the decalcifying
procedure.
The appliance does not switch off.
Close lid until it locks
Insert the strainer correctly.
The appliance cannot be switched on.
After operating with little or no water,
the appliance has not cooled down
suffiently.
Allow to cool a short time and
try again.
The display shows "E3" error code.
The thermostat is overheated.
Turn off the machine to cool
down or add water again.
Kettle alarm, "START" button light
flashing.
The NTC is short-circuited or
disconnected.
Return the machine to service
center.
Water temperature is lower than the
setting.
Temperature sensor is covered with dirt
after the kettle being misused warming
other food / beverage than water.
Clean Temperature sensor, a
pin shaped part, located in the
bottom of inner kettle tank.
Under TURBO program, water volume
is more than 200ml.
Under TURBO program, water
volume less than 200ml.
DISPOSAL
Recycle the materials with the symbol
. Put the packaging in applicable containers to recycle it. Help protect the
environment and human health.
Do not dispose appliances marked with the symbol
with the household waste. Return the product to your local
recycling facility or contact your municipal office.
AEG reserves the right to change products, information and specifications without notice.
K5-1-6ST_WaterKettle_AEG_202206_all lang rev 2.indd 15
K5-1-6ST_WaterKettle_AEG_202206_all lang rev 2.indd 15
2022-06-09 16:31:34
2022-06-09 16:31:34
